Inter-Tel AXXESS Manual page 347

Attach the other (smaller) connector on the floppy drive power cable to the floppy drive
5.
power connector on the EVMC.
Temporarily install the EVMC in slot 6 of the equipment chassis (Or any slot that has a
6.
vacant space to the right, to allow room for the floppy ribbon cable. The slot you
choose does not need to be programmed for an EVMC for this to work properly.)
A
7.
monitor's AC power cord and turn on the monitor's AC power switch.
Attach the keyboard to the keyboard connector on the front of the EVMC.
8.
After some initial power-up information, the monitor eventually displays "Waiting 5
9.
seconds. Press <ESC> to escape to the command line." Press
onds expire.
A flashing prompt shows "Shutting down in 5 seconds." Press
10.
onds expire. The monitor displays the OS/2 command prompt "[OS/2 C:\AVDAP]".
NOTE:
and then press the POWER DOWN button on the EVMC Card. Wait until you see "Wait-
ing 5 seconds. Press <ESC> to escape to the command line." Then press ESC on your
keyboard. The monitor displays the OS/2 command prompt "[OS/2 C:\AVDAP]".
Insert the EVMC Software Disk 1 in the PC's floppy disk drive.
11.
NOTE:
additional disks are also required.
At the [OS/2 C:\AVDAP] command prompt, enter "a:setup" and press
12.
follow the installation instructions displayed on the monitor.
To install secondary language prompts: Insert the Secondary Language Disk 1 in the
13.
PC's floppy disk drive. At the [OS/2 C:\AVDAP] command prompt, enter
"a:pmtinst" and press
on the monitor.
NOTE:
When the installation is complete, remove the last disk.
14.
Shut down the EVMC by using a small object to press the Power Down button on the
15.
front edge of the card. The EVMC goes through a shutdown process and the "OK To
Remove Card" LED flashes. When shutdown is complete, the LED is solidly lit.
NOTE:
EVMC from the equipment chassis for the next ten seconds. If you do not remove the
card within that amount of time, allow the card to reboot and wait for the "Card On-Line"
LED to light. Then you can repeat the shutdown process and remove the EVMC.
Remove the EVMC and disconnect the floppy drive.
16.
Re-install the EVMC. The EVMC reboots automatically when placed in the equipment
17.
chassis and the "Card On-Line" LED lights.
Program the Voice Processing Unit as described in PROGRAMMING.
18.
EVMC Voice Processing Software Installation
INTER-TEL
ttach the monitor to the 15-pin connector on the front of the EVMC. Then, plug in the
If you miss this five-second opportunity let the EVMC power up all the way up
All disks must be installed. For optional secondary language voice prompts,
ENTER
All five language disks must be installed.
When the "OK To Remove Card" LED turns green, it is safe to remove the
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
. Then follow the installation instructions displayed
Installation
before the five sec-
ESC
before the five sec-
ESC
. Then
ENTER
Page 3-161
3