Digital Keyset Card Configuration - Inter-Tel AXXESS Manual

Programming
® ®
INTER-TEL AXXESS
•
•
•
•
•
3.36 Voice Processor Connection: If more than eight Voice Processor ports are equipped,
enable this option by selecting the current Value and then selecting the check box to place a
check in it. (Or, remove the check mark if the Voice Processor has eight or fewer ports.) The
Voice Processor connection should be enabled on only the first OPC installed when there are
multiple OPCs. When this option is enabled, you must connect the cable from the OPC to the
Voice Processor's AIC. See
3.37 Time Slots Required: This is used for reference only. This tells you how many time
slots are needed to support the resources, as configured, to prevent voice channel blocking
(including 24 timeslots for a Voice Processor connection, if enabled). For further discussion of
time slots, see

Digital Keyset Card Configuration

3.38 When you double-click on a Digital Keyset Card (DKSC or DKSC-16), a list of the cir-
cuits appears on the right of the screen. This allows you to configure the DKSC, DKSC-16, or
DKSC-16+ card ports to support the various devices. DKSC and DKSC-16/DKSC-16+ capaci-
ties include the following:
•
•
•
•
•
Page 6-118
MANUAL VERSION 11.0 – May 2008
6 DTMF Receivers: To enable six additional DTMF receivers select this option.
16 Conference Circuits: To enable 16 conference circuits, select this option.
12 Conference Circuits and 4 DTMF: This enables 12 conference circuits and 4
DTMF receivers.
4 Enhanced Speakerphones: Select this option to support four shared enhanced speak-
erphone resource.
8 Standard Speakerphones: Select this option to support eight standard shared speak-
erphone resources.
NOTE:
Each DKSC-16 and DKSC-16+ has DSP resources to support speakerphones.
Their phones only use OPC speakerphone resources when the DKSC-16/DKSC-16+
resources are unavailable. DKSCs do not have on-board DSPs; their phones require
the OPC resources for speakerphones.
page 3-213
page 2-17 in SPECIFICATIONS.
Phone ports can be assigned for Single-Line Adapter (SLA) use. (Two single-line sets,
two DID trunks, or one of each can be connected to an SLA on a DKSC or DKSC-16
port.) See INSTALLATION,
To support the Off-Hook Voice Announce feature, a digital display phone must be
equipped with a PCDPM. (See
These phone ports do not require special configuration programming.
Up to 20 DSS/BLF units can be connected to digital display phones with PCDPMs.
Each of those phones can have up to four DSS/BLF Units in addition to using the Off-
Hook Voice Announce feature that is available to all phones with PCDPMs.
A digital display phone with a PCDPM (that does not have a DSS/BLF unit attached)
can use a Desktop Interface device.
Digital display phone ports with PCDPMs can be designated as system serial ports.
(There can be up to 32 system serial ports per system, including phones, OPC, CPC,
and CPU ports.) Phone system serial ports can be used for system programming, SMDR
report generation, and programming report generation. For proper serial port operation,
the phone circuit should also be programmed with camp-on tones disabled, extended
ring cadence enabled, different alerting cadence disabled, and different ringback
cadence disabled (see page
for details.
page 3-211, for special installation instructions.
page 3-191 in INSTALLATION for more information.)
6-210).
Digital Keyset Card Configuration