Inter-Tel AXXESS Manual page 351

11.8 After you have ensured the ATM Switch is programmed correctly, you can connect the
chassis together via the ATM Switch to form a large capacity node. See
about connector locations.
ASX-200BX
11.9 To program an ASX-200BX switch from default:
Establish a terminal session on the serial port and access the root menu (see steps 1-5 in
1.
the previous section).
At the root menu, type system and press
2.
Type startup and press
3.
Answer the following questions as indicated.
4.
What name do you want to give the switch? [Node X ATM SWITCH]
Type ICP ATM SWITCH and press
What is this switch's software license key? [Base]
Press
IP interface to configure (none, lane, ethernet) [ethernet]:
Type lane and press
What IP address do you want to give the switch?
Type 192.168.200.204 and press
And what network mask?
Type 255.255.255.0 and press
has IP address 192.168.200.204 with mask 255.255.255.0 on el0."
What is the address for the gateway router?
Press
tinuing..."
Configure Domain Name System (DNS) service? (yes, no) [yes]
Type no and press
Would you like to select a new password? (yes, no) [no]
Type yes and press
Enter the new password:
Type attitude and press
Please enter it again:
Type attitude and press
responds with "The password has been changed."
Configure SNMPv1/v2? (yes, no) [yes]
Type no and press
Configure SNMPv3? (yes, no) [no]
Press
Configure SNMP event logging station? (yes, no) [yes]
ASX-200BX
®
INTER-TEL AXXESS
. The screen displays a welcome message.
ENTER
. The switch responds with "The software license remains unchanged."
ENTER
.
ENTER
to select none. The switch responds with "Gateway has not been set. Con-
ENTER
.
ENTER
.
ENTER
ENTER
ENTER
.
ENTER
.
ENTER
®
MANUAL VERSION 11.0 – May 2008
.
ENTER
.
ENTER
.
ENTER
. The switch responds with "The switch now
ENTER
. The switch does not echo any characters.
. The switch does not echo any characters, but it
Installation
page 2-9 for details
Page 3-165
3