16. NETWORKING WIZARD
16.1 To access the networking wizard, select
or under System\Devices and Feature Codes\Nodes\<Node>, right-click in a blank portion of
the right window and select
65.
NOTE:
modify programming. To finalize programming done through the networking wizard, you must
click the Finish button.
16.2 The Networking Wizard allows you to program the following information:
•
Selecting the Networking Type—IPRC or T1/E1 (see
•
Selecting/Creating the Target Remote Node (see
•
Selecting/Creating Networking Boards (see
•
Updating the IP/PRI Configuration (see
•
Configuring IPRC Private Networking (see
•
Configuring T1/E1Private Networking (see
•
Updating Node Trunk/IP Connection Group Settings (see
•
Completing the Private Networking Setup (see
16.3 Selecting the Networking Type (IPRC or T1/E1): The first screen of the networking
wizard allows you to choose the type of private networking you would like to configure. By
default, IPRC Networking is selected.
16.4 Selecting/Creating the Target Remote Node: The second screen of the networking
wizard allows you to choose which node you would like to network with. If the node already
exists, select it from the list and then click
you to create and configure a new node as part of the Networking wizard.
Networking Wizard
INTER-TEL
Networking Wizard
The Back button on the wizard screens allows you to return to a previous screen to
®
®
AXXESS
MANUAL VERSION 11.0 – May 2008
Networking Wizard
. For troubleshooting information, see
page
6-87)
page
6-87)
page
6-89)
page
6-91)
page
6-91)
page
6-92)
page
page
6-94)
. The
Next
Create/Update New Node
Programming
from the Operations menu,
page 7-
6-93)
button allows
Page 6-87
6