Inter-Tel AXXESS Manual page 358

Installation
® ®
INTER-TEL AXXESS
C. UPLOADING CPU CARDS
NOTE:
tions are properly connected and on line, the system software only needs to be uploaded to the
master CPU020-Q/PCM-F card. However, if for some reason the third (slave) chassis is not
connected or is off line, the system software must also be uploaded to the slave CPU020-X/
PCM-F card.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Page 3-172
MANUAL VERSION 11.0 – May 2008
As long as both the first (master) and third (slave) chassis in tri-/quad-chassis installa-
Ensure that the programming PC is equipped with the DB Programming software. (See
page 6-17 in PROGRAMMING for details.)
If connected to a CP Server, stop the Call Processing Service (see
You cannot upload software if the CP Server is attempting to communicate with any of
the cards.
Attach an RS232 cable from an available COM port on the PC to the top RS232 port
(labeled CPU SERIAL PORT 1) on the CPU card. (See
drawing showing the serial ports.)
Select Start - Inter-Tel DB Programming -
appears.)
Click or select
New New
Enter a description, up to 40 characters, in the
identify the connection type. For example, if creating a setting for the CPU128 on node
2, enter Node 2 CPU128.
Select
CPU/CPC - Call Processing Cards
Select the appropriate "Port" and the desired "Speed" (bit per second rate). Estimated
upload times are listed in the following table.
Table 3-25.
BPS RATE
9600
19200
38400
57600
115,000
NOTE:
Be sure to select a bit rate that is compatible with the PC's capabilities. For
example, only PCs equipped with high-speed serial communications chips (e.g., 16550
UART) can use the 38400 and 57600 bit rates.
Enter the appropriate upload source file name in the File box or use the
to locate the file (the file ends with .bin). The file name usually depicts the country,
v e r s i o n n u m b e r, a n d
us_52F9_prod_cpu_512.bin indicates the file required for a CPU512 card that is
running the production version of 5.2F9 for the U.S. Make sure the complete file name
appears in the box.
If the system has just been powered up, wait at least three minutes to allow the system
to stabilize and finish printing power-up messages before performing the next step.
Click (or select Start from the File menu).
Start
Upload Utility
from the File menu to create an entry.
Settings For
as the Board type.
Estimated Upload Time
APPROX. UPLOAD TIME
15 Minutes
12 Minutes
6 Minutes
4 Minutes
2 Minutes
c a p a c i t y o f t h e
page C-9 for details).
Figure 3-50 on page 3-107
. (The main upload screen
field that allows you to
button
Browse
s y s t e m . F o r e x a m p l e ,
Uploading CPU Cards
for a