Inter-Tel AXXESS Manual page 798

Hide thumbs Also See for AXXESS:

Table of Contents

System Features

D. TERMINATING A DATA CALL

51.24 Termination of a data call may be accomplished in one of three ways:

51.25 To terminate data device connection:

MANUAL VERSION 11.0 – May 2008

Your data device can hang up. This causes the trunk or intercom channel to be released,

terminating the call to the other data device.

The other data device may hang up. When the call is disconnected, the

unlit. Depending on the type of device used, the data device may detect the loss of car-

rier and automatically terminate the entire connection. If the data device does not have

this capability, you must manually cause the data device to hang up.

The data call can be transferred to an associated phone's primary voice path (releasing

the data device) and then disconnected by the phone. Note however, that the

button will flutter rapidly if the data device does not hang up before the Inactivity timer

To have the data device disconnect the call: Use the appropriate commands for the

data device to instruct it to hang up. When the call is disconnected, the

To transfer the data call back to an associated phone before disconnecting the call:

While on or off hook:

Press the fluttering

to the party at the site of the remote data device. This can only be done if the

modem at the site of the remote data device can be turned off without disconnect-

ing the trunk.

To disconnect: If off hook, hang up. If on hook, press the Speaker button. The

button will flutter rapidly until the data device hangs up.

button goes off. If desired, speak

Terminating a Data Call

Chapters

Table of Contents