Inter-Tel AXXESS Manual page 372

Installation
® ®
INTER-TEL AXXESS
13.12 To wall mount the Model 8000 digital phones that have a support mechanism:
NOTE:
tion below) that fits into holes in the base.
1.
Support
Mechanism
2.
3.
4.
5.
6.
7.
8.
Page 3-186
MANUAL VERSION 11.0 – May 2008
The following instructions apply to phones that have a support mechanism (see illustra-
Collapse the support mechanism completely and secure it against the bottom housing of
the phone, as shown below.
Bottom Housing
(Base not shown)
Rivet Holes
Close the base completely so that it lies flat against the phone. (The two rivet holes on
the base align with the two rivet holes on the bottom housing of the phone.)
Plug the four-inch line cord into the jack on the back of the phone and thread the line
cord through the wall-mount knockout on the base.
Insert the two plastic rivets through the base and press them firmly into the holes on the
bottom housing of the phone. This locks the base to the phone.
Test the base to verify that it is securely locked to the phone.
Re-attach the metal plate to the phone base.
Plug the line cord into the jack on the wall-mount bracket and position the phone
securely on the wall-mount bracket.
Flip the handset hanger down to the horizontal position and lock it into place. This
holds the handset in place.
Rivet Holes
Wall Mounting Model 8500, 8520, and 8560 Phones
Base