Inter-Tel AXXESS Manual page 346

Installation
® ®
INTER-TEL AXXESS
EVMC Voice Processing Software Installation
10.92 The EVMC is shipped with OS/2 or Linux and the Voice Processing applications soft-
ware already installed on the hard disk drive. As a back-up, a CD containing the software is
also available.
NOTE:
Tel edGE Web site.
10.93 To upload the software to the EVMC you need:
•
•
•
10.94 If you are using secondary language prompts, you also need to do the following:
•
•
10.95 Use the following procedure to install the Voice Processing applications software via
floppy drive:
If the EVMC is not shut down properly before it is removed from the equipment chassis, the
database probably becomes corrupted, and the EVMC goes into an endless rebooting cycle.
1.
2.
3.
4.
Page 3-160
MANUAL VERSION 11.0 – May 2008
If the software is upgraded at a later time, the new versions are available on the Inter-
A set of Voice Processing software disks (make copies from the CD)
An external floppy drive (available in the Floppy Drive Kit 828.1486)
A keyboard and monitor
Copy the secondary language prompt files to floppy disks. This requires five disks. The
prompt files are located on the CPU64 software CD in the Axxess_64\CPU-
SOFT\EVMCSOFT\PROMPTS directory.
Make sure the Multilingual Support premium feature is licensed and select Secondary
Language in DB Programming.
Shut down the EVMC by using a small object to press the Power Down button on the
front edge of the card (see illustration on the previous page for its location). The EVMC
goes through a shutdown process and the "OK To Remove Card" LED flashes. When
shutdown is complete, the LED is solidly lit.
NOTE:
When the "OK To Remove Card" LED turns green, it is safe to remove the
EVMC from the equipment chassis for the next ten seconds. If you do not remove the
card within that amount of time, allow the card to reboot and wait for the "Card On-Line"
LED to light. Then you can repeat the shutdown process and remove the EVMC.
Remove the EVMC from the equipment chassis and lay it on a clean, flat, anti-static
surface.
When handling the EVMC be very careful not to damage the hard drive. It is sensi-
tive to vibration, pressure, and shock.
Attach the floppy drive cable to the floppy connector on the EVMC.
NOTE:
When plugging in the floppy drive or power connector ribbon cable, the red
stripe goes on the side closest to the power supply.
Attach the larger connector on the floppy drive power cable to the floppy drive.
CAUTION
CAUTION
EVMC Voice Processing Software Installation