Inter-Tel AXXESS Manual page 719

Single-Line Set: Select a trunk using one of the following methods:
3.
After dialing the call, you can place it on hold, transfer it, set up a conference, enter
4.
optional account codes, etc. as described in this manual. Some phones have menu but-
tons for easy use of outside call features.
If you dialed an invalid or restricted telephone number, you hear reorder tones and the
display shows INVALID OUTSIDE NUMBER or RESTRICTED OUTSIDE NUM-
BER.
To use the speakerphone, if equipped: If off hook, speak handsfree when the party
5.
answers. If on hook, press Speaker and hang up.
To change from speakerphone to handset: Lift the handset and speak. The Speaker
button goes off. You may later transfer back to the speakerphone by pressing the
Speaker button and hanging up.
To terminate the call: If on hook, disconnect by pressing the Speaker button. If off
6.
hook, hang up.
Placing Outside Calls
INTER-TEL
•
Enter the Outgoing Call feature code (8). This automatically selects an outgoing
trunk according to the programmed outgoing access mode for your station.
•
Enter a trunk group access code (92001-92208).
•
See the Automatic Route Selection (ARS) procedure on the next page.
You hear one of the following signals:
•
Outside Dial Tone: Manually dial, speed dial, or redial the desired telephone
number or use the outside directory. (Display phones show the numbers dialed.
When dialing is ended and the call is determined to be valid, the display shows the
elapsed time and call cost.) If you hear repeating reorder tones, you dialed a
restricted number. Also, if you dial too slowly and the Interdigit timers expire, the
call may be dropped, and you will hear repeating reorder tones. If using a phone
that is on hook, you may lift the handset to speak privately. Go to the next step. On
phones, an individual trunk or CALL button flashes slowly and the display shows
the call cost and elapsed time.
Menu button phone users may press one of the following menu buttons:
– OUTSIDE DIR: Appears only if you are using ARS. Press the button to use
the outside directory as described on
– STN SPEED DIAL: Press this button to use a station speed-dial number as
described on page 5-236.
– SYS SPEED DIAL: Press this button to use a system speed-dial number as
described on page 5-234.
– REDIAL: Press this button to redial the last number dialed (or saved) as
described on page 5-253.
•
Single Progress Tone: Enter a forced account code using the keypad buttons or a
pre-programmed speed-dial button (see
ACCOUNT CODE and the digits as they are entered. You hear outside dial tone
when the code is accepted. On phones, an individual trunk or CALL button flashes
slowly.
•
Repeating Reorder Tones: You are restricted from the trunk group chosen;
choose another trunk group. Or, you are restricted to using ARS only; try again
using ARS (see paragraph
DENIED.
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
page 5-241.
page 5-198). The display shows ENTER
26.5). The display shows OUTGOING ACCESS
System Features
Page 5-193
5