Inter-Tel AXXESS Manual page 397

14.7 The RJ45 connector on the Network Interface Card connects to the LAN via a cus-
tomer-provided standard network interface cable.
14.8 If configuring an ATM-based system, you should place the Voice Processing Unit close
to the first chassis that provides the first eight voice mail ports. The first chassis must also host
the Options Card (OPC), which is used for the remaining 32 voice mail ports.
14.9 When connecting the Voice Processing Unit to the first chassis, you can use either an
RS232 or TCP/IP connection. It is, however, recommended that you use TCP/IP because TCP/
IP is faster. The voice mail should also be configured to match the end-user's Ethernet net-
work.
A. HARDWARE INSTALLATION
14.10 Install the Voice Processing PC as outlined in the following steps. See
page 3-219
NOTE:
cated, properly grounded AC circuit for proper operation.
Ensure that the Voice Processing PC's AC power switch is turned off and the AC power
1.
cord is unplugged.
If the Audio Interface Card (AIC), Voice Processing Cards (VPCs), Video Card, and
2.
optional Fax Card are not already installed in the Voice Processing PC, proceed with
the installation as outlined in the following steps.
If the AIC, VPCs, Video Card, and optional Fax Card are already installed in the Voice
Processing PC, skip to step 9.
Remove the cover from the PC by removing the screws and sliding the cover off.
3.
If not already installed, install the Audio Interface Card (AIC) as follows (see
4.
97
a.
b.
Hardware Installation
INTER-TEL
for sample diagrams of the assembled PC.
Like the phone system itself, the Voice Processing PC must have its own isolated, dedi-
The cards and components are static sensitive. Handle the cards by the edges only
and keep them in their protective bags until they are to be installed. Do not bend or
touch the pins of the components or subject them to a static discharge. When work-
ing with the cards, use a properly terminated anti-static wrist strap and cover the
work surface with the bag that protected the card during shipping. Any static dis-
charge (no matter how small the charge) must be discharged from the body before
touching the cards or components. The warranty for this equipment does not cover
damage caused by static or mishandling. Cards or components damaged in such a
manner cannot be replaced.
on page 3-221:
Remove the bracket that covers the opening to the appropriate slot in the PC, and
set the bracket and screw aside.
NOTE:
To facilitate connection to the Voice Processing Cards (VPCs), the AIC
should be installed so that the VPCs can all be placed to one side of the card. (See
Figure 3-95 on page 3-219
Ensure that the AIC address selection DIP switches (S1) are set for address $3E0.
DIP switches 1 and 2 must be in the ON (closed) position and switches 3-6 must
be in the OFF (open) position.
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
CAUTION
for a sample card slot arrangement.)
Installation
Figure 3-95 on
Figure 3-
Page 3-211
3