Database Restore - Inter-Tel AXXESS Manual

Hide thumbs Also See for AXXESS:

Administrator's manual (342 pages)

User manual (118 pages)

User manual (43 pages)

Table of Contents

B. DATABASE RESTORE

Poor line quality may cause data transmission problems when the modem connection

exceeds 19200 baud. For this reason, Inter-Tel does not recommend using the CPC modem

to restore the database. If you attempt a restore using the modem, the database may

become corrupt.

11.3 When this option is selected, the window shown below appears. It allows you to restore

the database to disk during a programming session.

If the Database Restore feature is used during a remote programming session, all calls are

disconnected except the modem connection. Before restoring the database, ensure that the

circuit card being used for the modem connection will not be reconfigured during the restora-

tion (changed to a different type of card).

MANUAL VERSION 11.0 – May 2008

Restore From: Enter the name of the file where the database was saved in this box. Or,

to locate the file.

Start: To begin the operation, select

matically close the programming session.

Cancel: To stop an operation before it is completed, select

show that the operation was aborted by the user.

Canceling a restore operation will cause the system to default the database and ter-

minate the programming session.

If the number of multi-protocol endpoints in the database being restored exceeds

the number indicated in the license, an error message appears, and the database is

not restored. (This applies to software versions 8.1 and later.)

If the premium features enabled in the database being restored do not match the

premium features available in the software license, an error message appears, and

the system is inoperative. (This applies to software versions 8.0 and later.)

If the database being restored requires more Premium Feature units than the sys-

tem can support, you will see a warning message and the system will be inopera-

tive. (This applies to software versions 7.0 and earlier only.)

If the database being restored contains Voice Processor information and the sys-

tem does not have an operating Voice Processor, you will see a warning message

and no Voice Processor information will be loaded during the restore operation.

. When the operation is finished, it will auto-

. A message will