Inter-Tel AXXESS Manual page 359

Hide thumbs Also See for AXXESS:
Table of Contents

Advertisement

The software is automatically uploaded into flash memory on the CPU card. A warning
12.
message appears if you attempt to load CPU 512 Master software without a CPU 512
Slave card installed and communicating. You can continue the upload by clicking
or abort the upload by clicking
CPU 512 Slave card before it functions.)
If the upload fails to start, press the reset switch on the CPU card six times within three
13.
seconds, then retry the upload. If the upload fails while in progress, the red and yellow
LEDs on the CPU card blink rapidly (ten times per second), and the PC displays the
reason for the failure. If possible, correct the problem and retry the upload.
When the upload is complete, the system resets and the PC displays a message indicat-
14.
ing the operation was successful. Click
D. CHECKING SOFTWARE ON A CPC OR CPU
12.2 You can use the following procedure to check the validity of software on the CPC or
CPU card:
Attach a terminal (or a PC using terminal emulation software) to the IP port for a CPC
1.
or to SERIAL PORT 1 for a CPU. (Communication parameters for the serial port are
9600 bps, no parity, 8 bits, and 1 stop bit.)
NOTE:
before turning off the Power Supply.
Turn off the Power Supply on the first chassis and the third chassis (if used).
2.
NOTE:
Turn on the Power Supply on the first chassis or the third chassis while watching the
3.
power-up messages on the terminal.
You should see:
Boot Version 8.X
Inter-Tel 8.X Call Processing
If you do not see the correct information, upload the premium software from the pro-
4.
gramming PC to the CPC or CPU card using the Board Utility. To do so, select the
Board Utility
Checking Software on a CPC or CPU
®
INTER-TEL
AXXESS
. (If you click
No
If the system contains an EVMC, you must first shut down the EVMC properly
Be sure not to unplug CPCs or CPU card(s) with any Power Supply still ON.
menu from the Inter-Tel DB Programming.
®
MANUAL VERSION 11.0 – May 2008
, you must install software on the
Yes
and then exit the program.
OK
Installation
Yes
3
Page 3-173

Advertisement

Table of Contents
loading

Table of Contents