User-Programmable Feature Buttons - Inter-Tel AXXESS Manual

System Features
® ®
INTER-TEL AXXESS

14. USER-PROGRAMMABLE FEATURE BUTTONS

NOTE:
14.1 Individual phone buttons can be designated as "user-programmable" in the keymaps
during DB Programming. The installer can program the default feature codes (see PRO-
GRAMMING,
Default phone feature codes are shown on
tons can be programmed to enter any of the general feature codes.
14.2 Some phones have a display menu and a defaulted
ever, can be reprogrammed to use any of the Forward feature codes.) When the default
button is pressed, the display shows a menu of call forwarding options. The user must then
select the desired option by pressing the corresponding button next to the display. If the
FWD
options will not be displayed when the
as other phones. Any phone user can make any user-programmable button a
uses any one of the forwarding feature codes (355-358).
14.3 Secondary extension buttons (described on
grammable buttons during keymap programming. If so, the phone user can determine the pri-
mary station that is associated with the secondary extension button by using the procedures
given below.
14.4 To display the current button entries:
1.
2.
14.5 To return the buttons to default values:
14.6 To program a feature code in a user-programmable button or assign a primary
station to a secondary extension button:
NOTE:
Entering an extension number, using these instructions, will create a DSS/BLF button for that
extension number, not a speed-dial button (even if the button was previously programmed as a
speed-dial button).
1.
2.
Page 5-156
MANUAL VERSION 11.0 – May 2008
User-programmable feature buttons are available on Inter-Tel proprietary phones only.
page 6-221), and the station user can reprogram the feature codes as desired.
button is programmed to use any other Forward feature code (355-358), the forwarding
While on hook, enter the Review Keys code (396). The display shows PRESS THE
KEY TO REVIEW.
Press the feature or speed-dial button(s) to be displayed. The display shows the feature,
user name, or speed dial location and KEY VALUE: (feature code, extension number,
or location code). For a secondary extension button, the display shows SECONDARY:
(station).
While on or off hook, enter the Feature Key Default feature code (395). If off hook,
hang up. The display shows FEATURE KEYS DEFAULTED.
Speed-dial buttons are programmed using the procedure shown on the next page.
While on hook, enter the Program Keys feature code (397). Display phones show
PRESS THE KEY TO PROGRAM.
Press the desired feature or secondary extension button. The display shows the current
feature, station, or speed dial location name and KEY VALUE: (feature, extension, or
location code).
page 5-138. Up to 35 user-programmable phone but-
FWD
button is pressed; the phones operate the same
FWD
page 5-139) can be assigned to user-pro-
User-Programmable Feature Buttons
button. (This button, how-
FWD
button that
FWD