Inter-Tel AXXESS Manual page 745

NOTE:
toring.
33.10 The Record-A-Call feature code can be assigned to a user-programmable feature button.
If the feature button has a lamp, it flashes while the Record-A-Call conference is being set up
and is lit while the feature is active.
33.11 The programmer can set a maximum length for Record-A-Call messages. The Record-
A-Call Maximum Message Length timer can be set at 0-600 minutes. A 0 setting allows mes-
sages of any length, limited only by the available disk space. The default is 30 minutes. (This
overrides the mailbox's maximum message length setting. However, if a Record-A-Call mes-
sage exceeds the maximum message length, the mailbox will be considered full until that
Record-A-Call message is deleted.) See
33.12 As with any other conference call, any inside party involved in a Record-A-Call confer-
ence can use the Hold, Transfer, Agent Help, or other features. However, if any inside party
has enhanced speakerphone enabled, the enhanced mode will be disabled when the conference
begins and must be re-enabled if desired.
NOTE:
33.13 To use record-a-call:
Inter-Tel Phones: Press
1.
(385), or press the
RECORD-A-CALL.
Single-Line Sets: During a call, hookflash (press
feature code (385).
If required or allowed, enter the desired mailbox number. The display shows ENTER
2.
MAILBOX NUMBER. (If you do not enter a mailbox number, and you have a default
Record-A-Call mailbox, the system will automatically select your default mailbox. If
you do not have a default mailbox, the feature will time out or can be canceled by
pressing # or
You hear a confirmation tone when the Record-A-Call feature is activated. The display
3.
shows RECORD-A-CALL IN PROGRESS.
To turn off Record-A-Call, repeat step 1 or end the call. The display shows RECORD-
4.
A-CALL TERMINATED.
Record-A-Call
INTER-TEL
ATM systems do not support the simultaneous use of Record-A-Call and station moni-
Pressing Hold during a record-a-call terminates the record-a-call.
∞
RECORD-A-CALL
.)
ACCEPT
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
page 6-423 in PROGRAMMING.
or and dial the Record-A-Call feature code
SPCL
menu button. The display shows REQUESTING
) and dial the Record-A-Call
RECALL
System Features
Page 5-219
5