Inter-Tel AXXESS Manual page 811

b.
c.
d.
System Programming Using an Administrator's Station
®
INTER-TEL AXXESS
Press or to save the new message. The display shows DATA-
3.) ACCEPT
#
BASE UPDATED and then returns to the SELECT DND MESSAGE
prompt. (Or, to cancel your entry, press
NO UPDATE PERFORMED.)
To program another message, scroll to the desired message and repeat these
4.)
steps.
Press again to exit to the ENTER SYSTEM OPTION prompt.
5.)
#
Password: Allows you to set a password that limits access to the Administrator
programming feature. To select it, press
Then do the following:
The display shows CHANGE PASSWORD TO. Enter a password of up to
1.)
eight digits, then press
press #.)
The display shows VERIFY PASSWORD. Enter the password exactly as
2.)
you did in the step above, followed by
ENTER SYSTEM OPTION prompt. (If you hear reorder tones and see an
error message, the passwords did not match and you must start over at the
CHANGE PASSWORD prompt.)
Reminder Messages: Allows you to program the reminder messages used by the
stations. To select it, press
3
following:
The display shows SELECT REMINDER MSG #. Enter a message number
1.)
or scroll to the desired message. (To scroll to the correct message press the
Volume button or the
SCROLL
When the display shows the desired message, enter the new message as
2.)
described in paragraph 52.26
Press or to save the new message. The display shows DATA-
3.) ACCEPT
#
BASE UPDATED and then returns to the SELECT REMINDER MSG
prompt. (Or, to cancel your entry, press
NO UPDATE PERFORMED.)
To program another message, scroll to the desired message and repeat these
4.)
steps.
Press again to exit to the ENTER SYSTEM OPTION prompt.
5.)
#
Station Extensions: Allows you to assign new extension numbers to stations. To
select it, press or the
STN EXTENSION
4
If programming a station:
Press or
1.) CHANGE EXT
1
SION. Enter the extension number of the station to be programmed using
one of the following methods. (If you enter an invalid extension number, you
hear reorder tones and must try again.)
Enter a complete number: Enter the extension number using your keypad.
When a valid number is entered, the circuit information appears. Press
again to continue.
®
MANUAL VERSION 11.0 – May 2008
or
CANCEL
or the
PASSWORD
2
. (Or, to erase the password and leave it blank, just
#
. The display returns to the
#
or the menu button. Then do the
REMINDER MSGS
plus and
NEXT PREVIOUS
on page 5-277.
or CANCEL. The display shows
menu button.
. The display shows ENTER STATION EXTEN-
System Features
. The display shows
menu button.
menu buttons.)
#
Page 5-285
5