Inter-Tel AXXESS Manual page 343

You may see one of the following error indications.
Table 3-24.
Left LED blinking rapidly, right
LED blinking three on/one off
Left LED lit, right LED flashing
slowly
Left LED lit, right LED flashing
very slowly
To set up the RS232 interface between the CPC (or CPU) and the EVMC, plug one end
5.
of the mod-to-mod line cord into the RS232-C-TO-CPU jack. Then plug the other end
of the cord into an RS232 port on the system CPC (or CPU card). (The RS232-2 port is
the preferred location.) Do not use the Options Card port.
To enable voice path for the EVMC ports, attach one end of the DB15 interface cable
6.
(813.1739) to the DB15 PCM connector on the CPC (or CPU card). Then attach the
other end of the cable to the PCM connector on the front of the EVMC.
EVMC Installation
®
INTER-TEL AXXESS
EVMC LED Error Indications
LED Indication
No DSPM cards are installed and Voice Process-
ing Unit is shutting down.
Press the POWER DOWN button and wait for the
right LED to light before turning off the system
chassis. Then check the EVMC. If there is at least
one DSPM card, make sure it is seated properly. If
there are no DSPM cards, install one or two. If
using only one DSPM card, make sure it is in the
top socket, below the hard drive.
The EVMC PAL is not compatible with the CPU or
CPC.
Press the POWER DOWN button and wait for the
right LED to light before turning off the system
chassis. Then upload a CPC64 license (or replace
the CPU with a CPU64).
No PAL on the EVMC.
Press the POWER DOWN button and wait for the
right LED to light before turning off the system
chassis. Then install the appropriate PAL on the
EVMC.
®
MANUAL VERSION 11.0 – May 2008
Meaning
Installation
3
Page 3-157