Inter-Tel AXXESS Manual page 350

Installation
® ®
INTER-TEL AXXESS
C. PROGRAM THE ATM SWITCH
11.6 The programming differs for the ForeRunner LE155 and ASX-200BX switches.
ForeRunner LE155
11.7 To program a ForeRunner LE ATM switch from default:
1.
2.
3.
Page 3-164
MANUAL VERSION 11.0 – May 2008
Establish a terminal session on the serial port and access the root menu (see steps 1-5 in
the previous section).
At the root menu, type system startup and press
Answer the following questions as indicated.
What name do you want to give the switch? [ATM SWITCH]
Type ICP ATM SWITCH and press
What is this switch's software license key? [Base]
Press , The switch responds with "The software license remains unchanged."
ENTER
IP interface to configure (none, lane) [lane]:
Press to select the default.
ENTER
What IP address do you want to give the switch?
Type 192.168.200.204 and press
And what network mask?
Type 255.255.255.0 and press
has IP address 192.168.200.204 with mask 255.255.255.0 on el0."
What is the address for the gateway router?
Press to select none. The switch responds with "Gateway has not been set. Con-
ENTER
tinuing..."
Would you like to select a new password? (yes, no) [no]
Type yes and press
ENTER
Enter the new password:
Type attitude and press
Please enter it again:
Type attitude and press
responds with "The password has been changed."
What is the address of your ForeView management console?
Press to select none. The switch responds with "ForeView management console
ENTER
has not been set. Continuing..."
Only permit access from the ForeView management console? (yes, no) [no]
Press to select the default. The switch responds with "ForeView management
ENTER
console access has not been set. Continuing..."
Would you like to run LAN Emulation services on this switch? (yes, no) [no]
Type yes and press
ENTER
figured."
.
ENTER
.
ENTER
. The switch responds with "The switch now
ENTER
.
. The switch does not echo any characters.
ENTER
. The switch does not echo any characters, but it
ENTER
. The switch responds with "Your switch has now been con-
.
ENTER
Program the ATM Switch