Inter-Tel AXXESS Manual page 836

System Features
® ®
INTER-TEL AXXESS
•
53.15 With a European system, the programmer can determine whether absorbed digits and/or
toll field digits appear in the SMDR printout. As an example, assume the following number
was dialed: 89 (other system's trunk access code) - 01 (toll field) - 933 (STD code) - 402332
(number). The following programming options can be used:
•
•
53.16 Any combination of the above can be used. If all three fields are suppressed, only 602-
961-9000 (or 933402332) will print.
53.17 The programmer can also suppress or allow call information in the SMDR report
"Dialed Digits" field. The following options are available:
•
•
53.18 The programmer can determine which equipped station(s) and/or trunks will be
included in the report, and whether off-node devices will be included in reports. However, for
incoming calls, DISA calls, conference calls, and/or ring-in diagnostics, all calls are recorded
even when they involve stations not in the programmed station list.
53.19 SMDR can be programmed to record the elapsed time of calls in seconds
(S=XXXXXX) or hours and minutes (HH:MM). If programmed to record elapsed time in sec-
onds, the ELAPSED TIME field will show "S=XXXXXX" (XXXXXX represents the number
of seconds) for calls up to 999999 seconds long. For calls lasting longer than 999999 seconds,
ELAPSED TIME will show "HH:MM" (hours and minutes rounded up to the nearest minute).
53.20 The SMDR output report is printed as shown in
page heading (with the day of the week, date, month, year and column headings) is generated
just after midnight to show the change in date. A header is also printed after output from
another system source (alarm, informative message, etc.), using the same output device, inter-
rupted the SMDR output.
Page 5-310
MANUAL VERSION 11.0 – May 2008
Suppress Toll Digits: When this option is selected, toll digits will not appear in the
report. In the sample above, the toll field would be suppressed so that only 89-10288-
602-961-9000 prints.
Suppress Absorbed Digits: Absorbed digits (on local or PBX lines) will not appear in
the report if this option is selected. In the sample above, the absorbed digits (the other
system's trunk access code) would be suppressed so that only 01933402332 appears.
NOTE:
If absorbed digits are repeatable on a local line, the absorbed digits will not
appear in the SMDR report even when repeated.
Suppress Toll Digits: When this option is selected, toll digits will not appear in the
report. In the sample above, the toll field would be suppressed so that only 89-
933402332 prints.
Suppress Outside Party Number: Caller information that is received through ANI or
Caller ID [CLIP] will not appear if this option is selected.
Suppress Trunk Number: Information received through DID or DNIS [DDI in
Europe] will not be included in the report if this option is selected.
Figure 5-12 on the following page. A
Station Message Detail Recording (SMDR)