Inter-Tel AXXESS Manual page 985

NOTE:
#2 Echo Toll Field from the Operator and International Operator Route groups. (See
293.)
Send International Toll Digits
3.102 (Used for T1/PRI or E1/PRI trunks only) If enabled (default), the system sends interna-
tional toll digits (for example, 011) in the dial string in addition to the number type. If disabled,
the toll digits are stripped from the dial string for international calls using ISDN trunks. You
should enable this flag if the CO ignores the number type. By default, this is enabled.
Retry ARS Call If Call Rejected
3.103 This flag is for ISDN messaging for outgoing calls using ARS. If set to
will retry the additional channels and trunk groups programmed in ARS if the call is rejected
by the telco when receiving a specific cause value.
3.104 The symptom that will appear because of this flag is when an outgoing call is rejected
by a telco, where it causes the system (via ARS) to cycle through all the ISDN channels before
releasing/disconnecting the call.
3.105 This flag must remain enabled or set to
Interprise 3200s. This flag is enabled by default. The flag should be disabled on Pubic ISDN
circuits connected to a telco. If not using ARS with ISDN services, this flag does not apply.
3.106 When this flag is set to
son it was rejected. If this flag is set to
cause of the rejection is NOT one of the following causes:
•
Unallocated or unassigned number
•
The user is busy
•
No user is responding
•
Call rejected
•
Number has changed
•
Destination is out of order
•
Number format is invalid
•
There was a temporary failure
•
Congestion in the switching equipment
•
Requested circuit/channel is not available
•
Outgoing calls are barred
•
Incoming calls are barred
•
Service or option not available, unspecified
•
Service or option not implemented, unspecified
•
Mandatory information element is missing
•
Interworking, unspecified
T1, T1/PRI, or E1/PRI Card Configuration and Programming
INTER-TEL
If using ARS with National ISDN 2, and OSA is enabled, you must remove Dial Rule
, the system will not retry the ARS call, regardless of the rea-
No
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
on T1/PRI or E1/PRI circuits connected to
Yes
, the system will retry the ARS call as long as the
Yes
Programming
page 6-
, the system
Yes
Page 6-135
6