Inter-Tel AXXESS Manual page 379

Place the cables flat against the phone and carefully place the foot over the cables, as
6.
shown below on the right. For sample display phone PCDPM cable connections, see
Figure 3-88
13.23 Install the PC Data Port Module for a Model 8520 or 8560 Phone as outlined below. For
diagrams of the installation, see
Unplug the line cord and headset from the modular jacks on the back of the phone.
1.
Open the phone's base to its fully-extended position.
2.
Gently slide the access panel off the phone to expose the PCDPM pin connector (J10)
3.
on the phone's control board.
Align the PCDPM's J3 connector with the board's J10 connector and plug the PCDPM
4.
into place on the phone's board (see
If a DSS/BLF Unit (or a PC/output device) is attached to the PC Data Port Module,
5.
attach one end of a PCDPM-to-DSS interface cable (or PCDPM-to-RS232 interface
cable) to the 10-pin (J2) connector on the module, as shown in
end of the cable is later attached to the DSS/BLF Unit [or PC/output device] after it is
installed.) For complete RS232 cable pinout requirements, see
NOTE:
does not function properly. Make sure that the notched side of the cable's plastic con-
nector is facing away from the PCDPM board and that the smooth side lies flat against
it.
If a Modem Data Port Module is attached to the PC Data Port Module, plug the appro-
priate end of the PCDPM-to-MDPM interface cable into the 14-pin (J1) MDPM con-
nector on the PCDPM. (The other end of the cable is later attached to the MDPM after
it is installed.)
NOTE:
does not function properly. Make sure that the notched side of the cable's plastic con-
nector faces away from the PCDPM board, and the smooth side lies flat against it.
Carefully thread the cables connected to the PCDPM through the slots on the access
6.
panel. Re-attach the access panel to the phone.
Secure the access panel to the PCDPM and the phone using the mounting screw sup-
7.
plied in the PCDPM kit.
Optional Personal Computer Data Port Modules (PCDPMs)
®
INTER-TEL AXXESS
on page 3-201.
CABLES
Figure 3-89 on
page
If the correct end of the cable is not connected into J2, the attached device
If the correct end of the cable is not connected into J1, the attached device
®
MANUAL VERSION 11.0 – May 2008
CABLES
page 3-202 and Figure 3-90 on
3-202).
Figure
page 2-99.
Installation
page 3-203.
3-89. (The other
Page 3-193
3