Inter-Tel AXXESS Manual page 826

System Features
® ®
INTER-TEL AXXESS
Resetting the Modem
Do not reset the modem if it is connected to a DB Programming session. If you do, the pro-
gramming session is dropped, potentially corrupting the database. For this reason, Inter-Tel
strongly recommends that the System Administrator assign the modem extension to a DSS/
BLF button.
52.47 To reset the modem:
NOTE:
1.
2.
NOTE:
EXTENSION.
Assigning the Modem to a DSS/BLF Button
52.48 If desired, you can program a Direct Station Selection/Busy Lamp Field (DSS/BLF)
button to reflect the state of the CPC modem. If programmed, the DSS/BLF button indicates
the following states:
•
•
•
•
I. SYSTEM AND NETWORK ALARM REPORTING
52.49 To allow one administrator to monitor multiple nodes, the system provides both system
alarms and network-wide alarms.
System Alarms
52.50 The system's Alarm Reporting feature detects equipment failures. If there is a system
failure that affects service, a major alarm appears at all affected phones. If all phones in the
system are inoperative, any alarm messages are sent to the system's primary serial port (on the
CPC or CPU).
52.51 When a minor equipment failure occurs, a minor alarm is generated and appears on the
primary attendant's display and, if enabled, at Administrators' stations. If enabled in the Mes-
sage Print programming, the alarm also appears in the error/message report.
52.52 Alarms 1-99 indicate problems that can be corrected without calling service personnel.
Alarms 100-199 (phone system) and 200-299 (Voice Processing) require attention from service
personnel. Note that when a Voice Processing alarm is in effect, the phone system may be
functioning properly, but the Voice Processing Unit may be inoperative. See
TROUBLESHOOTING for a listing of the possible alarms and their meanings.
Page 5-300
MANUAL VERSION 11.0 – May 2008
A modem reset drops any call that is currently connected to the modem.
Enter the Modem Reset (9869) feature code. The display shows RESET MODEM EXT
#.
Enter the extension of the modem (local or off-node) to reset. The display shows
MODEM RESET.
If an invalid modem extension is entered, the display shows INVALID MODEM
Unlit: Modem is not active.
Fast Flash: Modem is ringing.
Slow Flash: Modem is disabled.
Solid: Modem is connected to a call.
CAUTION
page 7-12 in
Resetting the Modem