Inter-Tel AXXESS Manual page 980

Programming
® ®
INTER-TEL AXXESS
Table 6-20:
ISDN Timers (Continued)
Timer
Release (T308)
Restart
Acknowledge (T316)
Resume Acknowl-
edge (T318)
Re-Transmission
(T200)
Setup Request Ack.
(T303)
Suspend Acknowl-
edge (T319)
XID Request (T204) 20 tenths
* Currently, the overlap sending/receiving protocols are supported with PRI Net 5 and BRI Net 3 switch
types, which are prevalent in the Europe and Mexico markets.
Call Type
3.87 (T1/PRI Only) All Primary rate ISDN calls have a specific number type (International,
National, Network, or Local/Subscriber) and numbering plan field (ISDN, Telephony, or Pri-
vate) indicated in the call setup message to the public network peer. In certain cases, front end
equipment interfacing with the ISDN user (CPE) peer requires a specific number type and/or
numbering plan. The number type and numbering plan are programmable per call type for each
equipped primary rate card. The operation of this feature is transparent to the user. After the
number type and numbering plan are programmed, the Primary rate call setup message will
include this information for each call. To set the Primary Rate Call Type for a T1/PRI card,
select
Card). Then select
Description
3.88 You can enter a description for the card. Select its current Value and enter the descrip-
tion in the text box. Then press
Page 6-130
MANUAL VERSION 11.0 – May 2008
Default
Range
Value
4 1-255 If the appropriate Release response (Release Complete) is not
seconds received before this timer expires, the requesting system sends
another Release or releases the B-channel and Call Reference
value.
120 1-255 The system initiates this timer when a Channel Restart message
seconds is sent. The timer is terminated when the Restart Acknowledge is
received from the public network. If the Restart Acknowledge is
not received before this timer expires, the system sends a sec-
ond Restart message to the public network. If the timer expires a
second time and a Restart Acknowledge has not been received
from the public network, the system idles the respective channel.
9 1-255 (E1/PRI Only) If the appropriate Resume response (Resume
seconds seconds Acknowledge or Resume Reject) is not received before this timer
expires, the requesting system sends a Release Request.
10 1-65535 This timer controls the amount of time the ISDN Data Link layer
tenths will wait for an acknowledgment from the network before it trans-
mits a frame again.
4 1-255 If the appropriate Setup Request response (Alerting, Connect,
(9 for seconds Call Proceeding, Setup Acknowledge, or Release) is not received
4ESS) before this timer expires, the requesting system sends another
Setup Request or clears the call.
9 1-255 (E1/PRI Only) If the appropriate Suspend response (Disconnect,
seconds seconds Release, Suspend Acknowledge, or Suspend Reject) is not
received before this timer expires, the requesting system sends a
Suspend Reject.
1-65535 This timer controls how long the ISDN Link Data layer will wait for
tenths an XID response from the network before transmitting the XID
Request again. (XID parameter negotiation is not supported.)
and , then double-click on the card (or right-click and select Explore
System Cabinets
.
Call Type
ENTER
T1, T1/PRI, or E1/PRI Card Configuration and Programming
Purpose
or click on another field to save the change.