Inter-Tel AXXESS Manual page 371

Wall Mounting Model 8500, 8520, and 8560 Phones
NOTE:
necting and disconnecting cords (handset, headset, line) and/or cables (Ethernet, USB, power
supply) frequently. To connect and disconnect these cords and cables from a wall-mounted
phone, the user needs to remove the phone from the wall.
13.7 Because there are two types of bases used on the Model 8000 digital phones, two sets of
instructions for wall mounting the phones are included here. Determine which type of base the
phone has and follow the appropriate instructions.
13.8 For best results when wall mounting the Model 8000 digital phones, Inter-Tel strongly
recommends that you use the two plastic rivets shipped with the phone. After installed, the
plastic rivets lock the components into place, providing additional stability for wall-mounted
phones.
13.9 Model 8000 digital phones are shipped with a plastic adhesive label that covers the rect-
angular wall-mount knockout on the base of the phone. A portion of the adhesive label must be
removed to use the wall-mount knockout.
13.10 To wall mount the Model 8000 digital phones, you need an industry-standard wall-
mount bracket (sometimes called a wall jack assembly) and a four-inch line cord. Both of these
items are available through the Inter-Tel CommSource
13.11 To prepare the phone for wall mounting (regardless of base type):
Remove the metal plate from the base of
1.
the phone by removing the two plastic riv-
ets to unlock it from the back.
Slide the cover off. The two plastic rivets
2.
are not included on phones built prior to
May 2005.
Use a sharp blade to cut out the rectangular
3.
portion of the adhesive label covering the
wall-mount knockout (see diagram at
right).
Wall Mounting Model 8500, 8520, and 8560 Phones
INTER-TEL
Wall mounting the Model 8000 digital phones is not recommended if the user is con-
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
division or Inter-Tel Europe.
™
Plastic Rivet
Installation
On Large Base
On Small Base
Page 3-185
3