Inter-Tel AXXESS Manual page 601

Outside Party Number provided by Caller ID, if enabled at the station level.
5.
Outside Party Number provided by ANI service, if enabled at the station level.
6.
Call Routing Table Name, if the name is not blank.
7.
Trunk Group Name, if the name is not blank.
8.
Default Trunk Group Name (TG XXXXX).
9.
Display Line 2
10.80 The following criteria are used to display the number on the bottom line of the ring-in
display. This assumes that all of the necessary flags are properly set.
Outside Party Number provided by the Desktop Application, if available.
1.
Outside Party Number provided by Caller ID, if enabled at the station level.
2.
Outside Party Number provided by ANI service, if enabled at the station level.
3.
Number Absence Reason, such as Caller ID "OUT-OF-AREA" or "PRIVATE"
4.
(blocked) message.
RINGING IN display.
5.
10.81 ANI and Caller ID information is also sent to the Voice Mail application to provide the
caller's telephone number as part of the message envelope (in the U.S. only).
10.82 Caller Information features require the following special programming (in the U.S.
only):
•
The Advanced CO Interfaces feature license is required.
•
Caller information features require OPC programming (see
MING). Caller ID uses Caller ID receivers. Because DTMF receivers are required to
receive DID and ANI information, you should enable additional receivers.
•
Caller information display station flags must be enabled in DB Programming (see
page 6-211
•
The call information services must be enabled for the individual trunks (see
in PROGRAMMING).
Phone Displays
®
INTER-TEL AXXESS
in PROGRAMMING).
System Features
®
MANUAL VERSION 11.0 – May 2008
page 6-117 in PROGRAM-
5
page 6-253
Page 5-75