Inter-Tel AXXESS Manual page 597

Hide thumbs Also See for AXXESS:
Table of Contents

Advertisement

10.64 The following programming is required to use the DID feature:
Make sure the Advanced CO Interfaces premium feature is licensed (see
1.
PROGRAMMING).
If installing DID on a T1 or T1/E1 card, do the following:
2.
a.
b.
If installing DID using a Single-Line Adapter (SLA), do the following:
3.
a.
b.
Program the individual trunks. See
4.
Create a trunk group that contains the DID trunks. Program the trunk group to ring in to
5.
a Call Routing Table. (Note the Call Routing Table number. It is programmed in step 6.)
If there are only DID trunks in the trunk group, or the trunks are used only for incoming
calls, you can flag the trunk groups as "Incoming Only." See
Groups) in PROGRAMMING.
Program a Call Routing Table to be used by the DID trunk group. See
6.
Routing Tables) in PROGRAMMING. Also see
ing Call Routing Tables. Set up the table using the DID numbers to match the program-
ming performed in step 4.
Enable call information for phone displays. See Caller ID [CLIP] on the next page for
7.
more information.
Because DTMF receivers are required to receive DID and ANI information, you should
8.
enable additional receivers in OPC programming (see
MING).
Direct Inward Dialing (DID) Trunks (U.S. Only)
®
INTER-TEL
AXXESS
Install and configure a T1 Card, as described on
tion) in PROGRAMMING. Configure the appropriate circuits as "DID" and assign
extension numbers to the trunks. (If using an E&M trunk, see the instructions on
page
5-66.)
Program the T1 Card as required. See
GRAMMING.
Install the SLA on a keyset card circuit and configure the card, as described on
page 6-118
(System Configuration) in PROGRAMMING.
Program the station circuit as required. See
gramming) in PROGRAMMING.
®
MANUAL VERSION 11.0 – May 2008
page 6-126
page 6-126
(T1 Programming) in PRO-
page 6-200
(Individual Station Pro-
page 6-244
(Individual Trunk Programming).
page 5-89
for more information regard-
page 6-117
System Features
page 6-97
in
(System Configura-
page 6-236
(Trunk
page 6-319
(Call
in PROGRAM-
Page 5-71
5

Advertisement

Table of Contents
loading

Table of Contents