Inter-Tel AXXESS Manual page 683

Enter the feature code or extension number to be stored under that button. (If program-
3.
ming the FWD button, only Call Forwarding feature codes 355-358 will be accepted.)
You hear a single progress tone when the programming is completed. Display phones
show the newly programmed feature. If you attempt to program a non-programmable
button or enter an invalid code, you will hear repeating reorder tones, and the feature
code assigned to the button will remain unchanged. Display phones show NON-PRO-
GRAMMABLE KEY or FEATURE CODE INVALID.
NOTE:
Long Interdigit timer expires; the feature code assigned to the button remains
unchanged.
Repeat the procedure to program other buttons.
4.
14.7 To create a speed-dial location in a user-programmable button:
While on hook, enter the Program Keys feature code (397). Display phones show
1.
PRESS THE KEY TO PROGRAM.
Press the desired feature button. The display shows the current feature, user, or speed
2.
dial location name and KEY VALUE: (feature or name).
Enter the Station Speed-Dial feature code (382) or the System Speed-Dial feature code
3.
(381). The display shows SELECT STN SPEED or SELECT SYS SPEED.
Enter the desired speed-dial bin number (0-9 for station, 000-999 or 0000-4999 for sys-
4.
tem). The display shows the current contents of that bin.
Follow the instructions given on
5.
speed-dial bin. Administrators can use the procedures on
speed-dial locations.
User-Programmable Feature Buttons
®
INTER-TEL AXXESS
If you do not enter a feature code, the programming mode times out when the
page 5-238
System Features
®
MANUAL VERSION 11.0 – May 2008
to program a new number in a station
page 5-297 to program system
5
Page 5-157