Inter-Tel AXXESS Manual page 120

Hide thumbs Also See for AXXESS:

Table of Contents

Specifications

4.167 T1 Card with Primary Rate Interface (PRI) Daughter Card

4.168 A PRI Daughter card can be attached to up to eight T1 Cards to allow the system to

interface with an ISDN Primary Rate Interface trunk. Each PRI trunk provides a 23B+D inter-

face that delivers 23 bearer channels (B-channels), each operating at a rate of 64,000 bits per

second (bps), one data signaling channel (D-channel) also operating at 64,000 bps, and framing

information at 8,000 bps – for a total bandwidth of 1.544 megabits per second.

4.169 The PRI trunk is physically connected to the T1 Card using the RJ48C jack or the

DB15 connector normally used to connect a T1 trunk.

4.170 Each PRI trunk must be configured for the proper switch type of service (dedicated ser-

vice, on-demand B-channel selection, or a combination of the two). See

information. The Inter-Tel system is designed to support only AT&T 4ESS Custom, AT&T

5ESS Custom, National ISDN, National IDSN2, and DMS-100 switch types. No other switch

types are currently supported by the phone system.

4.171 The Inter-Tel system currently supports the following ISDN Primary Rate Interface ser-

4.172 T1 Gain Control (TGC) Daughter Card

4.173 If experiencing excessive E&M gain levels on a T1 Card that is not equipped with a

PRI Daughter card, two special software components and a TGC Daughter card (kit part no.

828.1397) can be attached to the card to provide 6dB of attenuation.

4.174 To use the TGC Daughter card, the T1 Card must be at revision level 2.G or later.

MANUAL VERSION 11.0 – May 2008

Automatic Number Identification (ANI)

On-Demand B-Channel Selection

Dialed Number Identification Service (DNIS)

Calling Party Number

Call-By-Call Service Selection

T1 Cards (T1Cs)

Chapters

Table of Contents