Converting A Dksc-16 To A Version 8.2 Or Later Firmware Iprc - Inter-Tel AXXESS Manual

Hide thumbs Also See for AXXESS:

Table of Contents

Converting a DKSC-16 to a Version 8.2 or Later Firmware IPRC

3.49 If a slot is programmed as a DKSC-16, and there are keysets and dual single-line ports

programmed on that card, the following dialog box appears if you change that card to a device

v8.2 or later firmware IPRC. (This occurs in local mode only.)

3.50 This dialog lists all of the keyset and dual single-line ports that were programmed for

the DKSC-16. It allows you to convert these extensions to IP phones and/or IP SLAs. If you

convert a device, the circuit is programmed based on the following:

If the circuit was programmed for a keyset, it is converted to an IP device.

If the circuit was programmed for a dual single-line port, it is converted to an IP SLA.

Only one circuit, however, is used.

If the circuit was programmed as any other device (e.g., Keyset/MDPM), it is not listed

in the dialog and is automatically unequipped.

3.51 While in this dialog, you can enter the MAC address of any IP device or IP SLA that

terminates at this card. Or, you can import MAC addresses from a .txt file (see

for more information).

3.52 After you have entered or imported the MAC addresses for the appropriate devices,

invalid or if no MAC address is specified (i.e., a red X appears next to the extension), that cir-

cuit is unequipped. Circuits are equipped beginning with port 2.

3.53 If you want to manually assign the circuits, click

cuits as described on

slot to any card, other than a CPC or CPU card. If, however, you change the first slot to some-

thing other than a keyset card, you must reprogram the Auto Attendant in a keyset card.

Converting a DKSC-16 to a Version 8.2 or Later Firmware IPRC

This feature is available only in local mode.

. If the MAC address is valid, the extension is converted. If the MAC address is

The first card slot does not require a keyset card (e.g., DKSC16). You can change this

MANUAL VERSION 11.0 – May 2008

. Then program the cir-

Table of Contents