Inter-Tel AXXESS Manual page 761

38.9 The system speed-dial numbers and names are stored in battery-backed RAM and will
not be erased in the event of a power failure.
38.10 The system speed-dial numbers and names are programmed by the installer or at any
Administrator station. (See
Viewing System Speed-Dial Numbers
38.11 To view system speed-dial numbers and names:
NOTE:
While on hook, press
1.
display shows REVIEW SYS SPEED # (0000-4999).
Enter the desired location code (0000-4999) or press the
2.
display shows the programmed name and number.
If desired, scroll forward through the speed-dial locations in alphabetical order by press-
3.
ing the high end of the
pressing the low end of the
Repeat steps 2 and 3 for each speed-dial location to be viewed. Or, press
4.
CEL to terminate this feature.
To automatically select a trunk and dial the displayed number, press
5.
Dialing System Speed-Dial Numbers
38.12 To dial system speed-dial numbers at a phone:
If desired, lift the handset and select an outgoing trunk. (You may skip this step.)
1.
Press
2.
REVIEW SYS SPEED # (0000-4999). Non-display phone users hear a confirmation
tone.
Enter the location code (0000-4999) for the desired number. If you have not selected a
3.
trunk, press
select a trunk. Or, press the ARS button, a trunk button, a trunk group button, or the
phones show the number dialed unless it is a non-display number.) If you hear reorder
tones, your station is restricted from dialing the selected number. If the display shows
INVALID BIN NUMBER, you entered an invalid speed-dial location code.
38.13 To dial system speed-dial numbers at a single-line set:
Lift the handset and select an outgoing trunk.
1.
Hookflash (press
2.
hear a confirmation tone.
Enter the location code (0000-4999) for the desired number. The number is automati-
3.
cally dialed. If you hear reorder tones, your station is restricted from dialing the
selected number.
Viewing System Speed-Dial Numbers
INTER-TEL
page 5-297
If you make a mistake, use the
SYS SPDL
VOLUME
VOLUME
or enter the System Speed-Dial feature code (381). The display shows
SYS SPDL
or the
ACCEPT
#
button to select a trunk. The number is automatically dialed. (Display
OUTGOING
) and enter the System Speed-Dial feature code (381). You
RECALL
® ®
AXXESS MANUAL VERSION 11.0 – May 2008
for Administrator programming instructions.)
button to backspace.
MUTE
or enter the System-Speed Dial feature code (381). The
SEARCH
button or the button, or scroll backward by
NEXT
button or the
PREVIOUS
menu button to accept the number and automatically
System Features
menu button. The
button.
or CAN-
.
#
Page 5-235
5