Logging Source-Interface - Dell S4810 Reference Manual

logging source-interface

Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
S4810
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
1592
Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For the management interface on the RPM, enter the
keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1 and the port
range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. Tthe range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Simple Network Management Protocol (SNMP) and Syslog