Logging Source-Interface - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

When you use the no logging on command, messages are logged only to the

logging buffered

logging console

logging monitor

logging source-interface

Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog

logging source-interface interface

To disable this command and return to the default setting, use the no logging

source-interface command.

Not configured.

CONFIGURATION

Simple Network Management Protocol (SNMP) and Syslog

Introduced on the S-Series.

Introduced on the C-Series.

— enables logging to the Syslog server.

— sets the logging buffered parameters.

— sets the logging console parameters.

— sets the logging parameters for the terminal connections.

Enter the following keywords and slot/port or number

information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For the Management interface on the stack-unit, enter

the keyword ManagementEthernet then the slot/port

information. The slot range is from 0 to 1. The port range

For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a Null interface, enter the keyword null then the Null

interface number.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.