Snmp-Server Host - Dell Force10 Z9000 Reference Manual

notify
access
list-name
ipv6
name
access-list-name
ipv6
name
Defaults As above.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.10.2
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage The following Example specifies the group named
Information authentication and encryption and read access limited to the read named
Example
FTOS#conf
FTOS(conf)# snmp-server group harig 3 priv read rview
FTOS#
Related
show snmp group
Commands
each group.
show running-config

snmp-server host

Configure the recipient of an SNMP trap operation.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax snmp-server host ip-address | ipv6-address [traps | informs]
[version 1 | 2c | 3] [auth | no auth | priv] [community-string]
[udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [traps |
informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type] command.
name
(OPTIONAL) Enter the keyword notify followed by a name (a string
of up to 20 characters long) as the notify view name.
access- (Optional) Enter the standard IPv4 access list name (a string up to 16
characters long).
access-list- (Optional) Enter the keyword ipv6 followed by the IPv6 access list
name (a string up to 16 characters long).
(Optional) Enter both an IPv4 and IPv6 access list name.
access-list-
Introduced on the Z9000.
Added support for the access parameter.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: The number of configurable groups is limited to 16 groups.
– displays the group name, security model, view status, and storage type of
– displays the SNMP running configuration.
harig as a version 3 user requiring both
rview .
1371