Ipv6 Ospf Areaid; Ipv6 Ospf Cost - Dell PowerConnect M6348 Cli Reference Manual

console(config-if-vlan15)#ipv6 ospf

ipv6 ospf areaid

Use the ipv6 ospf areaid command in Interface Configuration mode to set the OSPF area to
which the specified router interface belongs.
Syntax
areaid
ipv6 ospf areaid
no ipv6 ospf areaid areaid
areaid — Is a 32-bit integer, formatted as a 4-digit dotted-decimal number or a decimal value.
•
It uniquely identifies the area to which the interface connects. Assigning an area id which
does not exist on an interface causes the area to be created with default values. (Range: 0-
4294967295).
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example defines the OSPF area to which VLAN 15 belongs.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf areaid 100

ipv6 ospf cost

Use the ipv6 ospf cost command in Interface Configuration mode to configure the cost on an
OSPF interface.
Syntax
cost
ipv6 ospf cost
no ipv6 ospf cost
cost — Cost for OSPF interface. (Range: 1-65535)
•
813