Enable Inline-Power - Extreme Networks ExtremeWare XOS Command Reference Manual

Power Over Ethernet Commands

enable inline-power

enable inline-power
Description
Enables PoE power to all ports on all slots.
Syntax Description
This command has no arguments or variables.
Default
Enable.
Usage Guidelines
You can control whether inline power is provided to the system by using the
command and the
enabled.
Enabling inline power starts the PoE detection process used to discover, classify, and power remote PDs.
NOTE
If your chassis has an inline power module and there is not enough power to supply a slot, that slot will not be
powered on; the slot will not function in data-only mode without enough power for inline power.
Disabling inline power using the
traversing the port. And, disabling the port using the
power supplied to the port.
However, when you issue the command
power is also disabled; that slot is totally offline.
NOTE
Inline power cannot be delivered to connected PDs unless the BlackDiamond 8800 chassis and module are
powered.
To deliver inline power to connected PDs, you must also reserve adequate power for the slot with the
PDs using the
428
enable inline-power
disable inline-power
configure inline-power budget slot
command. By default, inline power provided to all ports is
command does not affect the data traffic
disable port
on a slot holding a PoE module, the inline
disable slot
command.
disable inline-power
command does not affect the inline
ExtremeWare XOS 11.3 Command Reference