Extreme Networks ExtremeWare XOS Command Reference Manual page 523

probeDateTime—If you configure the probeDateTime object, you can view the current date and time
●
of the probe.
probeResetControl—If you configure the probeResetControl object, you can restart a managed device
●
that is not running normally. Depending on your configuration, you can do one of the following:
Warm boot—A warm boot restarts the device using the current configuration saved in non-
■
volatile memory.
Cold boot—A cold boot causes the device to reset the configuration parameters stored in non-
■
volatile memory to the factory defaults and then restarts the device using the restored factory
default configuration.
NOTE
You can only use the RMON features of the system if you have an RMON management application and have enabled
RMON on the switch.
RMON requires one probe per LAN segment, and standalone RMON probes have traditionally been
expensive. Therefore, the approach taken by Extreme Networks has been to build an inexpensive
RMON probe into the agent of each system. This allows RMON to be widely deployed around the
network without costing more than traditional network management. The switch accurately maintains
RMON statistics at the maximum line rate of all of its ports.
For example, statistics can be related to individual ports. Also, because a probe must be able to see all
traffic, a stand-alone probe must be attached to a nonsecure port. Implementing RMON in the switch
means that all ports can have security features enabled.
To view the status of RMON polling on the switch, use the
command displays information about the switch including the enable/disable state for
management
RMON polling.
To view the RMON memory usage statistics for a specific memory type (for example, statistics, events,
logs, history, or alarms) or for all memory types, use the following command:
show rmon memory {detail | <memoryType>}
Example
The following command enables the collection of RMON statistics on the switch:
enable rmon
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
command. The
show management
enable rmon
show
523