Extreme Networks ExtremeWare XOS Command Reference Manual page 607

3 Assign a tag value to the VMAN.
Use the following command:
configure vman <vman-name> tag <tag>
4 Add the ports in the tunnel to the VMAN.
5 Configure VMAN member ports as tagged on switch-to-switch ports and untagged on the ingress
and egress ports of the tunnel.
Use the following command:
configure vman <vman-name> add ports [ all | <port_list> ] {untagged | tagged |
nobroadcast }
NOTE
You must configure the VMAN tunnel egress, or trunk, port as untagged so that the VMAN header is stripped from
the frame.
The Extreme Networks default Ethernet type for VMAN is 088a8.
You must use mutually exclusive names for:
VLANs
●
VMANs
●
Ipv6 tunnels
●
NOTE
Beginning with ExtremeWare XOS software version 11.3 you can tunnel multicast traffic on the BlackDiamond 10K
series switch. To assign an IP address to a VMAN, use the
Example
The following command creates a VMAN named fred:
create vman fred
History
This command was first available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
configure vlan ipaddress
create vman
command.
607