Enable Inline-Power Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

enable inline-power ports

enable inline-power ports [all | <port_list>]
Description
Enables PoE power currently provided to all ports or to specified ports.
Syntax Description
all
port_list
Default
Enable.
Usage Guidelines
Disabling inline power to a port immediately removes power to any connected PD. By default, inline
power provided to all ports is enabled.
To deliver inline power to ports with connected PDs, you must also reserve power for the slot with the
PDs using the
configure inline-power budget slot
power for the port, that port moves into a Denied state.
NOTE
If your chassis has an inline power module and there is not enough power to supply a slot, that slot will not be
powered on; the slot will not function in data-only mode without enough power for inline power.
Disabling inline power using the
traversing the port. And, disabling the port using the
power supplied to the port.
Example
The following command enables inline power to ports 4 and 5 on slot 3:
enable inline-power ports 3:4-5
History
This command was first available in ExtremeWare XOS 11.1.
ExtremeWare XOS 11.3 Command Reference
Enables inline power to all ports on the switch.
Enables inline power to the specified ports.
command. If you do not have enough reserved
disable inline-power
disable port
enable inline-power ports
command does not affect the data traffic
command does not affect the inline
431