Configure Snmpv3 Add Notify - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Managing the Switch

configure snmpv3 add notify

configure snmpv3 add notify [[hex <hex_notify_name>] | <notify_name>] tag
[[hex <hex_tag>] | <tag>] {volatile}
Description
Adds an entry to the snmpNotifyTable.
Syntax Description
hex_notify_name
notify_name
hex_tag
tag
volatile
Default
The default storage type is non-volatile.
Usage Guidelines
Use this command to add an entry to the snmpNotifyTable. When a notification is to be sent, this table
is examined. For the target addresses that have been associated with the tags present in the table,
notifications are sent based on the filters also associated with the target addresses.
Example
The following command sends notifications to addresses associated with the tag type1:
configure snmpv3 add notify N1 tag type1
History
This command was first available in ExtremeWare XOS 10.1.
The
hex_notify_name
Platform Availability
This command is available on all platforms.
132
Specifies the notify name to add. The value is to be supplied as a colon
separated string of hex octets.
Specifies the notify name to add in ASCII format.
Specifies a string identifier for the notifications to be sent to the target. The
value is supplied as a colon separated string of octets.
Specifies a string identifier for the notifications to be sent to the target in
ASCII format.
Specifies volatile storage. By specifying volatile storage, the configuration is
not saved across a switch reboot.
and parameters were added in ExtremeWare XOS 11.0.
hex_tag
ExtremeWare XOS 11.3 Command Reference