Configure Dot1P Type - Extreme Networks ExtremeWare XOS Command Reference Manual

configure dot1p type

configure dot1p type <dot1p_priority> {qosprofile} <qosprofile>
Description
Configures the default QoS profile to 802.1p priority mapping.
Syntax Description
dot1p_priority
qosprofile
Default
The default mapping of each 802.1p priority value to QoS profile is shown in
Table 21: Default 802.1p priority value-to-QoS profile mapping
BlackDiamond 10K switch QoS
Priority value profile
0 QP1
1 QP2
2 QP3
3 QP41
4 QP51
5 QP6
6 QP7
7 QP8
Usage Guidelines
An 802.1p priority value seen on ingress can be mapped to a particular QoS profile and with specific
bandwidth management and priority behavior.
BlackDiamond 10K switch only. If a port is in more than one virtual router, you cannot use the 802.1p
feature. If you attempt to configure 802.1p information on a port that is in more than one virtual router,
the system returns the following message:
Warning: Port belongs to more than one VR. Port properties related to diff serv and
code replacement will not take effect.
BlackDiamond 8800 family of switches and Summit X450 switch only. You must create the QoS profile first,
using the
create qosprofile [QP2| QP3 | QP4 | QP5 | QP6 | QP7]
802.1p information to QoS profile 2 through 7.
ExtremeWare XOS 11.3 Command Reference
Specifies the 802.1p priority value. The value is an integer between 0 and 7.
Specifies a specific QoS profile.
BlackDiamond 8800 family of switches and
Summit X450 switch default QoS profile
QP1
QP1
QP1
QP1
QP1
QP1
QP1
QP8
configure dot1p type
Table 21.
command, to map the
693