Disable Diffserv Replacement Port - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

disable diffserv replacement port

disable diffserv replacement port [<port_list> | all]

Disables the replacement of DiffServ code points in packets transmitted by the switch.

Syntax Description

Usage Guidelines

The DiffServ replacement feature is disabled by default.

BlackDiamond 10K switch only. If a port is in more than one virtual router, you cannot use the DiffServ

feature. The default VLAN DiffServ examinational mappings apply on ports in more than one VR. If

you attempt to configure DiffServ information on a port that is in more than one virtual router, the

system returns the following message:

Warning: Port belongs to more than one VR. Port properties related to diff serv and

code replacement will not take effect.

The specified ports are the ingress ports.

The following command disables DiffServ replacement on selected ports:

disable diffserv replacement ports 1:2,5:5,6:6

This command was first available in ExtremeWare XOS 11.0.

Platform Availability

This command is available on all platforms.

ExtremeWare XOS 11.3 Command Reference

Specifies a list of ports or slots and ports to which the parameters apply. \

Specifies that DiffServ replacement should be disabled for all ports.

disable diffserv replacement port

Extremeware xos 11.3