Chapter 2: Commands For Accessing The Switch - Extreme Networks ExtremeWare XOS Command Reference Manual

2 Commands for Accessing the Switch
This chapter describes commands used for:
Accessing and configuring the switch including how to set up user accounts, passwords, date and
●
time settings, and software licenses
Managing passwords
●
Configuring the Domain Name Service (DNS) client
●
Checking basic switch connectivity
●
Enabling and displaying licenses
●
Returning the switch to safe defaults mode
●
ExtremeWare XOS supports the following two levels of management:
User
●
Administrator
●
A user-level account has viewing access to all manageable parameters, with the exception of:
User account database
●
SNMP community strings
●
A user-level account can change the password assigned to the account name and use the
command to test device reachability.
An administrator-level account can view and change all switch parameters. It can also add and delete
users and change the password associated with any account name. The administrator can disconnect a
management session that has been established by way of a Telnet connection. If this happens, the user
logged on by way of the Telnet connection is notified that the session has been terminated.
The DNS client in ExtremeWare XOS augments certain ExtremeWare XOS commands to accept either IP
addresses or host names. For example, DNS can be used during a Telnet session when you are accessing
a device or when using the
The switch offers the following commands for checking basic connectivity:
●
ping
●
traceroute
The command enables you to send Internet Control Message Protocol (ICMP) echo messages to a
ping
remote IP device. The
traceroute
and a destination endstation.
ExtremeWare XOS 11.3 Command Reference
command to check the connectivity of a device.
ping
command enables you to trace the routed path between the switch
ping
39