Configure Log Target Severity - Extreme Networks ExtremeWare XOS Command Reference Manual

configure log target severity

configure log target [console | memory-buffer | nvram | primary-msm |
backup-msm | session | syslog [all | <ipaddress> | <ipPort> {vr <vr_name>}
[local0 ... local7]]] {severity <severity> {only}}
Description
Sets the severity level of messages sent to the target.
Syntax Description
console
memory-buffer
nvram
primary-msm
backup-msm
session
syslog
all
ipaddress
ipPort
vr_name
local0 ... local7
severity
only
Default
By default, targets are sent messages of the following severity level and above:
console display—info
●
memory buffer—debug-data
●
NVRAM—warning
●
session—info
●
syslog—debug-data
●
primary MSM—error (modular switches only)
●
backup MSM—error (modular switches only)
●
If a virtual router is not specified, VR-Mgmt is used.
ExtremeWare XOS 11.3 Command Reference
Specifies the console display.
Specifies the switch memory buffer.
Specifies the switch NVRAM.
Specifies the primary MSM.
NOTE: This parameter is available only on modular switches.
Specifies the backup MSM.
NOTE: This parameter is available only on modular switches.
Specifies the current session (including console display).
Specifies a syslog target.
Specifies all of the remote syslog servers.
Specifies the syslog IP address.
Specifies the UDP port number for the syslog target.
Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
Specifies the local syslog facility.
Specifies the least severe level to send (if the keyword only is omitted).
Specifies that only the specified severity level is to be sent.
configure log target severity
479