Configure Stpd Ports Priority - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

configure stpd ports priority

configure stpd <stpd_name> ports priority <priority> <port_list>
Description
Specifies the port priority of the port in the specified STPD.
Syntax Description
stpd_name
priority
port_list
Default
The default setting is 16.
Usage Guidelines
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If your STPD has a name
unique only to that STPD, the keyword
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
By changing the priority of the port, you can make it more or less likely to become the root port or a
designated port.
A setting of 0 indicates the highest priority.
The range for the
Example
The following command assigns a priority of 1 to slot 2, ports 1 through 5 in STPD s0:
configure stpd s0 ports priority 1 2:1-2:5
History
This command was available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
956
Specifies an STPD name on the switch.
Specifies a numerical port priority value. The range is 0 through 31.
Specifies one or more ports or slots and ports.
stpd
parameter is 0 through 31.
priority
is optional.
ExtremeWare XOS 11.3 Command Reference