Configure Stpd Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

configure stpd add vlan

configure stpd <stpd_name> add vlan <vlan_name> ports [all | <port_list>]
{[dot1d | emistp | pvst-plus]}
Description
Adds all ports or a list of ports within a VLAN to a specified STPD.
Syntax Description
stpd_name
vlan_name
all
port_list
dot1d
emistp
pvst-plus
Default
All ports are in
Usage Guidelines
To create an STP domain, use the
command.
This command adds a list of ports within a VLAN to a specified STPD provided the carrier VLAN
already exists on the same set of ports. You can also specify the encapsulation mode for those ports.
You cannot configure STP on the following ports:
Mirroring target ports
●
Software-controlled redundant ports
●
Netlogin ports
●
If you see an error similar to the following:
Error: Cannot add VLAN default port 3:5 to STP domain
You might be attempting to add:
Another 802.1D mode STP port to a physical port that already contains an 802.1D mode STP port
●
(only one 802.1D encapsulation STP port can be configured on a particular STP port)
A carrier VLAN port to a different STP domain than the carrier VLAN belongs
●
A VLAN/port for which the carrier VLAN does not yet belong
●
940
Specifies an STPD name on the switch.
Specifies a VLAN name.
Specifies all of the ports in the VLAN to be included in the STPD.
Specifies the port or ports to be included in the STPD.
Specifies the STP encapsulation mode of operation to be 802.1D.
Specifies the STP encapsulation mode of operation to be EMISTP.
Specifies the STP encapsulation mode of operation to be PVST+.
mode, except those in STPD s0, whose default setting is
emistp
create stpd
command. To create a VLAN, use the
ExtremeWare XOS 11.3 Command Reference
mode.
802.1d
create vlan