Configure Telnet Vr - Extreme Networks ExtremeWare XOS Command Reference Manual

configure telnet vr

configure telnet vr [all | default | <vr_name>]
Description
Configures the virtual router used on the switch for listening for Telnet connections.
Syntax Description
all
default
vr_name
Default
If you specify , the virtual router VR-Mgmt is used.
default
Usage Guidelines
NOTE
The BlackDiamond 8800 family of switches and the Summit X450 switch do not support user-created VRs.
You must be logged in as administrator to configure the virtual router.
Beginning with ExtremeWare XOS 11.2, the switch accepts IPv6 connections.
If you specify , the switch listens on all of the available virtual routers for Telnet connections.
all
The specifies the name of the virtual router to use for Telnet connections.
vr_name
If you specify a virtual router name that does not exist, the switch displays an error message similar to
the following:
configure telnet vr vr-ttt
%% Invalid input detected at '^' marker.
Example
The following command configures the switch to listen for and receive Telnet requests on all virtual
routers:
configure telnet vr all
ExtremeWare XOS 11.3 Command Reference
Specifies to use all virtual routers for Telnet connections.
Specifies to use the default virtual router for Telnet connections. The default
router is VR-Mgmt.
Specifies the name of the virtual router to use for Telnet connections.
NOTE: The BlackDiamond 8800 family of switches and the Summit X450
switch do not support user-created VRs.
^
configure telnet vr
163