Received Packet Count (Rx Pkt Count)—The total number of good packets that have been received
●
by the port.
Received Byte Count (RX Byte Count)—The total number of bytes that were received by the port,
●
including bad or lost frames. This number includes bytes contained in the Frame Check Sequence
(FCS), but excludes bytes in the preamble.
Received Broadcast (RX Bcast)—The total number of frames received by the port that are addressed
●
to a broadcast address.
Received Multicast (RX Mcast)—The total number of frames received by the port that are addressed
●
to a multicast address.
Port Monitoring Display Keys.
refresh is enabled (the default behavior).
Table 16: Port monitoring display keys with auto-refresh enabled
Key(s)
U
D
[Esc]
0
Table 17
describes the keys used to control the display that appears if you auto-refresh is disabled.
Table 17: Port monitoring displays keys with auto-refresh disabled
Key
Q
[Space]
Example
The following command displays port statistics for slot 1, ports 1 through 2 on a modular switch with
auto-refresh disabled:
show ports 1:1-1:2 statistics no-refresh
The following is sample output from this command:
Port Statistics
Port
Link
Tx Pkt
Status
Count
================================================================================
1:1
A
1:2
R
================================================================================
Link Status: A-Active, R-Ready, NP-Port not present
The following command displays port statistics for all ports on the Summit X450 switch with auto-
refresh enabled (the default behavior):
show ports statistics
ExtremeWare XOS 11.3 Command Reference
Table 16
describes the keys used to control the display that appears if auto-
Description
Displays the previous page of ports.
Displays the next page of ports.
Exits from the screen.
Clears all counters.
Description
Exits from the screen.
Displays the next page of ports.
Tx Byte
Count
7241
2722608
0
0
Rx Pkt
Rx Byte
Count
Count
14482
3968068
0
0
show ports statistics
Rx
Rx
Bcast
Mcast
0
0
0
0
555