Unconfigure Qosprofile - Extreme Networks ExtremeWare XOS Command Reference Manual

QoS Commands

unconfigure qosprofile

unconfigure qosprofile {ingress | egress} {ports [<port_list>|all]}
Description
Returns the ingress rate shaping parameters, which is an ingress QoS profile, or the egressing QoS
values to default values.
Syntax Description
ingress
egress
ports
port_list
all
Default
Default values differ by platform.
BlackDiamond 8800 family of switches (formerly known as Aspen) and Summit X450 switch only. The
default values for the two default egressing QoS profiles (QP1 and QP8) on the BlackDiamond 8800
728
Specifies all ingress QoS profiles for specified ports. The default ingress values
are as follows:
• for 1G I/O modules—IQP1 and IQP2
• for 10G I/O modules—IQP1 to IQP8
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
Specifies an egress QoS profile for specified ports. The default egress values
are as follows:
• QP1—1, Low (the lowest priority)
• QP2—2, LowHi
• QP3—3, Normal
• QP4—4, NormalHi
• QP5—5, Medium
• QP6—6, MediumHi
• QP7—7, High
• QP8—8, HighHi (highest priority)
If you do not specify ingress or egress, the command returns all egress QoS
values to default.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
Specifies unconfiguring the QoS profiles on specified ports.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
Specifies a list of slots and ports to which the parameters apply.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
Specifies that this applies to all ports on the device.
NOTE: This parameter is available only on the BlackDiamond 10K switch.
ExtremeWare XOS 11.3 Command Reference