Show Snmpv3 Target-Addr - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Managing the Switch

show snmpv3 target-addr

show snmpv3 target-addr {[[hex <hex_addr_name>] | <addr_name>]}
Description
Displays information about SNMPv3 target addresses.
Syntax Description
hex_addr_name
addr_name
Default
N/A.
Usage Guidelines
Use this command to display entries in the SNMPv3 snmpTargetAddressTable. If no target address is
specified, the entries for all the target addresses will be displayed.
To view the source IP address, use the
Example
The following command displays the entry for the target address named A1:
show snmpv3 target-addr A1
The following is sample output from this command:
Target Addr Name
TDomain
TAddress
TMask
Timeout
Retry Count
Tag List
Params
Storage Type
Row Status
Storage Type
Row Status
220
Specifies an identifier for the target address. The value is to be supplied as a
colon separated string of hex octets.
Specifies a string identifier for the target address.
show management
: A1
: 1.3.6.1.6.1.1
: 10.201.31.234, 162
:
: 1500
: 0
: defaultNotify
: v1v2cNotifyParam1
: NonVolatile
: Active
: NonVolatile
: Active
command.
ExtremeWare XOS 11.3 Command Reference