Disable Dot1P Replacement Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

QoS Commands

disable dot1p replacement ports

disable dot1p replacement ports [<port_list> | all]
Description
Disables the ability to overwrite 802.1p priority values for a given set of ports.
Syntax Description
port_list
all
Default
N/A.
Usage Guidelines
The dot1p replacement feature is disabled by default.
BlackDiamond 10K switch only. If a port is in more than one virtual router, you cannot use the 802.1p
feature. If you attempt to configure 802.1p information on a port that is in more than one virtual router,
the system returns the following message:
Warning: Port belongs to more than one VR. Port properties related to diff serv and
code replacement will not take effect.
NOTE
The specified ports are ingress ports.
Example
The following command disables 802.1p value replacement on all ports:
disable dot1p replacement ports all
History
This command was available in ExtremeWare XOS 11.0.
Platform Availability
This command is available on all platforms.
712
Specifies a list of ports or slots and ports to which the parameters apply.
Specifies that 802.1p replacement should be disabled for all ports.
ExtremeWare XOS 11.3 Command Reference