Configure Eaps Failtime - Extreme Networks ExtremeWare XOS Command Reference Manual

EAPS Commands

configure eaps failtime

configure eaps <name> failtime <seconds>
Description
Configures the value of the failtimer the master node uses for EAPS health-check packets.
Syntax Description
name
seconds
Default
The default is 3 seconds.
Usage Guidelines
Use the
failtime
master node waits before the failtimer expires. The
configured value for
Increasing the
packet when the network is congested.
NOTE
You configure the action taken when the failtimer expires by using the
command.
action
In ExtremeWare XOS 11.0, the failtimer range was 2 to 60 seconds.
Example
The following command configures the failtimer value for the EAPS domain "eaps_1" to 15 seconds:
configure eaps eaps_1 failtime 15
History
This command was first available in ExtremeWare XOS 11.0.
The range for the failtimer was changed to 2 to 300 seconds in ExtremeWare XOS 11.1. The default value
for the failtimer remains unchanged.
898
Specifies the name of an EAPS domain.
Specifies the number of seconds the master node waits to receive a health-
check packet before the failtimer expires. Default is 3 seconds, and the range
is 2 to 300 seconds.
keyword and its associated
. The default value is three seconds.
hellotime
value provides more protection by waiting longer to receive a health-check
failtime
parameter to specify the amount of time the
seconds
parameter must be set greater than the
seconds
configure eaps failtime expiry-
ExtremeWare XOS 11.3 Command Reference